Hello I has shopped since 4 wochen new Ramspeicher namely are the Corsair Dominator 4 GB * 2 x 2Gb DDR2 with 1066mhz

www.techpowerup.com / reviews / Corsair / TWIN2X4096 8500C5DF / images/memoryinfo.jpg

and now asks to, with ramriegel stands 2.1 V, however, my TurboV gives him to 2.3 V this is normal?`

ps. I have tried spannung on 2.To switch 1v afterwards he has only whimpered and has gone out, with neustart he has worth again on 2.3 V switched.
I hope you can help me!

So I have now on 2.1 V opposed. Except the funny start

In
5sek from
again in

claps tadelos

Funnily, the fact that does not function with you so.

In From In is normal by radical changes in the form of tensions or FSB Straps (speak, for example, the divisor change RAM between FSB 266 and 333 MHz).

Ram memory often does not function with the printed values. For it are selected the values and are automatically put.
Being, nevertheless, tired, or?

well, above all it hardens is, however, he runs Solidly one can never know what really goes off... till present, however, everything still runs cramig I have nobody buck if he really sometimes burns out.
I have: Mainboard Asus M4N72 E, AMD x4 in 9950 black edition, EVGA 260 SE GTX and OCZ ModXstream per 700 watts

There nothing burns out.... Being I never think whom a Ram burnt through, because before he this acts a mistake is produced and the Werkel stands. Knowing one, nevertheless, from the Overclocking... more heat, more mistake, Fall, no heat more...
If he should run with less tension, then you must defuse the timing a little, so z.B on the values of the afterwards slower Rams.

However, Hum, well, this 2 viecher were not quite cheap I will notice it or. if bluescreen appears, then I know give. ps. I have looked just over again in the manual from motherboard and can say he unterprotects the Ram's. Well then, I thank over again for the quick answer. peace with you:daumen

ey marius, I also have 250gb maxtor and Win 7 smartly smartly.